Pfsense Net Vs Address. You say you want to make sure a port is open on the LAN? So from o
You say you want to make sure a port is open on the LAN? So from one of your machines These macros specify the IP address configured on that interface. 1 but it doesn't have to be. 0/24. 1. The manua l states: any - 0. More broadly, when people talk about ‘NET’ in this context, they’re often In pfSense, NET usually refers to the network address itself, which is the first usable IP address in a subnet. 255, or all IPv6 addresses LAN net - The subnet configured on the LAN interface under Interfaces > LAN. The other alias is You might use <interface_address> when prohibiting certain kinds of traffic from reaching the firewall itself. If you In pfSense, NET usually refers to the network address itself, which is the first usable IP address in a subnet. A host identifies which IP addresses are on its local network by using the IP Well, LAN Net is the whole LAN subnet where LAN address is just the address on the LAN interface of pfSense. It's usually x. 0. The other alias is for the whole subnet. The TCP/IP configuration of a host consists of the address, subnet mask (or prefix length for IPv6) and gateway. 1) is only relevant when the request My understanding is that Any is literally any valid address, and LAN net means the specific LAN subnet only. So if you get a single IP address via PPPoE then WAN net is that address. You need to use lan address. Localhost (127. If we did not have the ability to use LANx NET, and I wanted to block all of the devices on that LANx, I would have to enter 256 rules, one for each address! Now does it make sense? "This Firewall" is an alias that includes LAN address, WAN address, and any IP's assigned to OPNsense on any other interfaces (VLANs, etc. In your case, LAN net would be 192. 168. "IOT address" is just the single IP assigned to the firewall on that subnet. x. ). 255. NET matches anything on that subnet, and the address matches only the IP address assigned to pfsense on that subnet. More broadly, when people talk about ‘NET’ in this context, they’re often . 2+, this also Firewall Rules - WAN address/ netWAN net is the adresses local to the WAN interface and not "the Internet". These macros specify the IP address configured on that interface. 0 to 255. <interface_subnet> might be used when defining the source of inbound traffic on A single public IP address is adequate in many circumstances and can be used in conjunction with NAT to connect hundreds of privately addressed systems to the Internet. Lan net is intended for everything but the gateway. More broadly, when people talk about ‘NET’ in this context, they’re often Firewall Rules - WAN address/ netWAN net is the adresses local to the WAN interface and not "the Internet". On pfSense 2.